skip to content

Jesse Hehr’s 24' Kenworth Custom Tool Truck

Mandan, ND compass


Jesse Hehr chose the Kenworth T270 to power his new custom tool truck. A traditional 5-shelf setup is in oak with red mahogany stain.


  • Paccar PX-7 300HP diesel
  • Allison 2500HS transmission
  • 26,000 lb GVWR
  • 2,000 lb lift gate
  • Dual west coast style exhaust stacks
  • Exterior storage boxes
  • 3,000 BTU propane furnace
  • Pro Air EZ-5 low profile evap
  • 15,000 BTU Coleman low profile A/C units
  • (3) tool box areas with smooth plate; 78", 70" & 44"
  • L-shaped desk with LED lighted knife case, pull-out writing surface, mini fridge and microwave under desk
  • 24" monitor
  • Grey slat wall above desk and 78" tool box area
  • Diamond plate ceiling slats
  • Recessed LED lighted oak puller cabinet and chrome laced pegboard on rear door
  • Air tool display
  • Double floor drawers with diamond plate fronts
  • Dual 6-drawer stack with carpet hammer rack above

back to top